Installation Instructions

Installation requirements
DN00283911 © Nokia Corporation 33 (43)
Issue 2 DRAFT 1 - en Nokia Proprietary and Confidential
Note
Caution
Table 5. Connectors, cables and recommended fuses
In general, the fuses for cable protection have to be rated according to the national
electrical safety regulations.
4.7 Painting the Main Unit cover
If desired, the MU cover can be painted to make it better blend into the
surrounding environment. Some dark colours with higher absorptivity may be
restricted.
Nokia recommends that for painting the cover, a primer-topcoat combination of
Beckers TD 130 primer (for priming) and Beckers TH 141 paint (for surface
painting) be used. Other paints suitable for polycarbonate surfaces may also be
used.
Do not use any paint that contains alkalis, esters, ketones, aromatic, chlorinated,
or fluorinated hydrocarbons, since these may damage the cover. Paint containing
these chemicals can only be used if approved by the manufacturer for painting
polycarbonate objects.
The selected paint must be UV and weather-resistant, and suitable for
temperatures ranging from -40 °C to +50 °C (-40 °F to 122 °F). For environmental
conditions, refer to ETS 300 019-1-4:1992 class 4.1.
To paint the Nokia InLite cover:
1. Remove the MU cover as instructed.
2. Before painting, detach the cable cover and the cable cover support from
each other to prevent them from sticking to each other by paint and to
ensure that paint is applied evenly. The cover top can also be detached from
the cover by unscrewing the Torx T20 screws (see Figure ).