Instruction Manual

Repair
DN00283717 © Nokia Corporation 13 (26)
Issue 2 DRAFT 1 - en Nokia Proprietary and Confidential
WARNING
3.1.2 Disconnecting the laptop PC
Use this procedure to disconnect the laptop PC after all faults have been located,
diagnosed, corrected and tested.
To disconnect the laptop PC
1. Close the Supervisor software and shut down the laptop PC.
2. Disconnect the laptop PC and LMP cable from the MU.
3. Store the laptop in a secure location.
4. Carefully locate the MU plastic cover over the assembly and push back,
making sure that the cover locking guides are aligned with the back-plate
recesses.
5. Push the cover down to secure it to the back-plate.
6. Lock the MU front cover.
3.2 Correcting faults
All persons who perform operations on this equipment should be advised of
the potential dangers.
General warnings and cautions are provided in Nokia InLite: Warnings and
Cautions.
The following procedure provides general instructions on how to locate, repair
and test a repair.
To locate and correct a fault in the InLite system
1. Connect the laptop PC and start the Supervisor software as described in
Section 3.1.1.
2. Locate the fault, using the Supervisor software.
3. Perform the maintenance procedure relevant to the fault.
4. Check that the fault has been corrected, using the Supervisor Software.
5. Shut down and disconnect the laptop PCas described in Section 3.1.2.