Instruction Manual
Maintenance
12 (26) © Nokia Corporation DN00283717
Nokia Proprietary and Confidential Issue 2 DRAFT 1 - en
Note
Note
Note
Figure 3. Com Port Setup window
The Nokia default setting is: 9600 Baud, 8NI (8 bit data, no parity bit, 1 stop bit).
If this setting is to be changed, the Com port chosen should be a com port
not used by other peripherals. If the com port chosen is already in use, an error
message is issued telling the operator to choose another port.
The Com Port setup window can also be accessed via the Configure button in the
main window of the Supervisor software.
3. In the main window, click on the System auto Acq button. The Supervisor
software will show any alarms that exist.
It is possible that at power up, the BkUp alarm (BkUp) will be active.
If this alarm is present, click on the BkUp button in the main window, then close
the BkUP window.
For more information about the Supervisor software, refer to the document Nokia
InLite Commissioning