Installation Instructions

Installation

D N 00203719 © N okia Corporation 61 (79)

I ssue 2 D RAFT 1 - en N okia Proprietary and C o n f idential

Note

7. Connect the antenna cable between the antenna and the RU.

antennas can be connected to the RU. Ensure that the ante

neatly routed and secured.

If only one antenna is connected, use a 50 ohm termination for

connector.

Do not over-tighten the connectors. If N-type connectors are

hand is sufficient.

8. Connect the FO cables (uplink and downlink) to the RU.

9. Connect the power cable to the RU.

10. Screw the mounting rack in place, using the four M3 x 20

11. Insert the enclosure cover by sliding it downwards from t

backplate along the bars on both sides of the backplate.

12. Secure the cover to the wall using one M6 x 40 Fisher scr

5.8.4 RU IP64 Installation

Installing the RU IP64

It is most important that the documentation showing the layout

cable identification is consulted at all times.

1. Locate the holes drilled for the mounting of the RU or loc

pole.

2. Remove the ten M5 x 16 screws from front of the RU cover t

cover to the enclosure and open the cover.

3. Fix the enclosure backplate to the wall at designated posi

M6 x 40 mm Fisher screws provided.

4. Open the splice tray cover and fix the splice holder.

5. Draw the optic cables very carefully into the enclosure t

devoted to them.

6. Arrange the optical splices in the splice holder and clos

7. Connect the FO cables (uplink and downlink) to the RU.