Installation Instructions

Installation

58 (79) © N okia Corporation D N 00203719

N okia Proprietary and C o n f idential I ssue 2 D RAFT 1 - en Status

Note

6. Fix the Remote Unit into the mounting rack using the five M3

screws provided.

7. Connect the antenna cable between the antenna and the RU. Up t

antennas can be connected to the RU. Ensure that the antenna c

neatly routed and secured.

If only one antenna is connected, use a 50 ohm termination for the

connector.

Do not over-tighten the connectors. If N-type connectors are used,

hand is sufficient.

8. Connect the FO cables (uplink and downlink) to the RU.

9. Connect the power cable to the RU.

10. Screw the mounting rack cable cover in place, using the four M

(3) provided.

5.8.3 RU IP53 Installation

Installing the RU IP53, mounting rack, mounting rack cover and

antennas

It is most important that the documentation showing the layout of

cable identification is consulted at all times.

1. Locate the holes drilled for the mounting of the RU or locate

pole.