Installation Instructions

Installation
40 (79) © N okia Corporation D N 00203719
N okia Proprietary and C o n f idential I ssue 2 D RAFT 1 - en Status
Note
Note
Figure 15. L ocal Unit jum per in the OFF position
3. Go to the Main Unit and Remote Unit placing window of the Sup
e
Software. Add a note against each unused RU to indicate that t
unused.
If the Supervisor software is not running at this time, make a not
e
remember to record this information at the first available opportu
n
Adding more RUs to an LU
1. Check which Rx and TX optical ports are used.
2. Move the appropriate jumper to the ON position by moving the j
onto the right-hand two pins of the jumper connector.
3. Go to the Main Unit and Remote Unit placing window of the Sup
e
Software. Remove the existing note against the RU which indicat
RX was unused.
If the Supervisor software is not running at this time, make a not
e
remember to record this information at the first available opportu
n