Installation Instructions

Installation
D N 00203719 © N okia Corporation 27 (79)
I ssue 2 D RAFT 1 - en N okia Proprietary and C o n f idential
Note
Note
1. Insert the assembly bolts with washers into the bolt hole
s
blocks. Refer to 1 in Figure .
2. Attach the square nuts to the ends of the bolts. Screw the
to prevent them from falling off from the ends of the bol
t
Figure .
3. Slide one bolt with the square nut to the slot at the sid
e
Refer to 3 in Figure .
4. Screw the bolt on enough to prevent the bolt and the nut
f
from the side of the back block. Refer to 4 in Figure .
To install the pole brackets and the mounting frame onto a
Before taking the mounting frame up the pole, carry out the tas
1 to 3 inclusive.
Figure shows the installation configuration for mounting the
b
mounting frame on a pole.
1. Insert the two M4 x 20 mm fixing screws to the uppermost s
the mounting frame (B1 and B2 in Figure ). Tighten the sc
r
bear the weight of the MU.
2. Position the U-plate onto the screw holes R3 and R4 on th
e
frame. Refer to Figure .
The larger holes on the U-plate must be facing down. Refer to
3. To fix the U-plate and the lower pole bracket to the mount
i
the M6 x 20 mm Allen screws through the U-plate and throug
h
R3 and R4 into the lower front block. Refer to Figure . Us
e
with a 6 mm Allen bit to tighten securely.
4. Position the pre-assembled upper pole bracket on the pole.
the holes for screws R1 and R2 are on the upper edge of t
h
Refer to Figure .
5. Rotate the back block of the upper pole bracket so that th
e
inserted with the square nut into the slot at the side of
6. Tighten the bolts evenly to fix the upper pole bracket to
torque socket spanner/wrench with an 8 mm Allen bit to ti
g
(8.85 ft/lb.).
7. Attach the mounting frame to the upper bracket from fixin
g
R2 with M6 x 20 mm Allen screws. Refer to Figure . Use a
t
with a6 mm Allen bit to tighten.