Installation Instructions

Installation
D N 00203719 © N okia Corporation 23 (79)
I ssue 2 D RAFT 1 - en N okia Proprietary and C o n f idential
3. Drill the holes in the wall and clean them out. Insert an
c
wall, depending on the wall material.
4. Install the mounting frame from the upper anchor screw hol
in Figure ) onto the wall. Use appropriate anchor screws.
the screws (6.3 x 38) supplied by Nokia, use a 6 mm hexag
o
tighten.
5. Position the U-plate (refer to Figure ) onto the second lo
w
holes (R3 and R4). Make sure the U-plate is in the correct
larger holes on the U-plate must be facing downwards as p
r
Figure .
6. Screw the anchor screws through the U-plate and anchor sc
r
and R4 into the wall.
7. Insert the M4 x 20 mm Allen screws to the upper fixing ho
l
the mounting frame (B1 and B2 in Figure ).
8. Hang the MU on the upper fixing screws. Do not tighten ye
t
9. Position the L-beam on the back of the MU into the U-plate
).
10. Tighten the upper MU fixing screws (B1 and B2 in Figure ).
11. Tighten the two offset screws (B3, B4) M6 x 25mm on the L-
b
U-plate from the underside. Tighten to 24 Nm. Refer to Fi
g