Operation Manual

Table Of Contents

Nokia MetroSite GSM Base Station, Requirements for Installation and Operation

30 (38) © Nokia Networks Oy Internal Copy DN9913471

Issue 1 en DRAFT 2 Draft

Note

Figure 7. Areas used for holding the cable cover parts during painting

8. Spray paint over the outside surface of the cover. Spraying should be done

at room temperature with relative air humidity of 50-65%.

The maximum thickness of the paint should not exceed 100 µm.

9. Dry the parts either in an oven or let the paint dry at room temperature

according to the paint manufacturer’s drying instructions.

The temperature of the drying oven must not exceed 90 °C (194 °F).

10. After the paint is dry, attach the cover top to the cover. Tighten the screws

to 1.6 Nm (1.18 ft-lb).