User's Manual

Removing modules with the pull-out tool
(for maintenance only)
11
Installing module front covers
10
1. Fix the maintenance strap. (Pole or wall only)
Attach the first and second snap hooks of the maintenance strap to the front
cover.
Attach the third snap hook of the maintenance strap to the external cable entry.
2. Place the cover on top of the module front panel.
3. Fix the screws. Tighten the screws to
2.0 - 2.5 Nm (1.5-1.8 ft-Ib)
Module front panel covers are installed.
Check list
2
3
1
1
1
Module front covers
Maintenence strap
Caution:
1. Remove the front covers and cable entries.
2. Remove the module screws.
3. Hook the pull-out tool through the hole in
front of the module.
4. Pull until the unit comes loose.
Do not completely remove the module or
carry it with the pull-out tool.
Removing System Module with the pull-out tool
4
Pull-out tool