User's Manual

No software applications or drivers are loaded onto the computer.
 Connect the Power cord and Ethernet cable to the CPE.
 Plug the power cord into an AC outlet. The unit will turn on.
 Rotate the CPE until you find the best signal strength. More lights = better signal.
 Power off your computer.
 Plug the other end of the Ethernet cable into the Ethernet connector of your computer.
 Power on your computer.
 When the CPE obtains Ethernet communication with your computer and completes its
connection to the wireless network, the lights stop blinking and remain on.
Procedure to Install the Unit
PMS 376 C
100%
Checking the CPE’s lights
2
The lights on the CPE blink to indicate the strength of
the signal received by the CPE. The CPE is equipped
with an internal antenna that receives this signal
from your Internet service provider.
The more lights that blink on the CPE, the stronger
the signal that the CPE receives.
If the CPE is not able to receive any signal, the lights
blink in sequence. Choose another location in the
building in which to operate the CPE.
After the installation is complete the lights remain
continuously lit. This indicates the CPE can provide
you with high-speed Internet service.
Finding the best signal from the ISP
3
1. Place the CPE on a table or shelf.
2. Point the back of the CPE (the side without the logo)
toward a window. Remove your hands from the
CPE for a few seconds.
3. Note the number of lights on the CPE that blink.
4. Point the CPE to the left of the starting point, then to
the right. At each point, note how many lights blink.
5. Re-orient the back of the CPE to the direction it was
pointed when the most lights blinked.
6. Ensure that the lights stay on after you release your
hands from the CPE.
PMS 376 C
100%
A4 (210mm x 297mm) folds to A6 (105mm x 148mm)