User's Manual

7-80 Configuring, Installing, and Using Carrier Infrastructure
Attaching the switch and power supply to the rack
Figure 7.2 shows where the switch and power supply should be installed on the rack, in
relation to the cabinet and RMBs.
Installing the RMBs into the cabinet
To install the RMB in the cabinet:
1 Grasp the RMB by handles on each side of the RMB.
2 Slide the RMB into the cabinet, aligning the guides along the side of the RMB with the
gliders inside the cabinet.
To ensure you align the RMB properly into the pre-installed harness connections, there is a
guide pin on the back of the cabinet that fits into a guide pin opening on the back of the
RMB. This guide pin will help the connectors on the back to align correctly.
3 When the RMB is properly installed and aligned in the cabinet, the plastic latches on the
side of the front plate snap into place.
Note: Always make sure the RMB is slid greater than halfway into the cabinet. An RMB that
is not at least halfway installed in the cabinet could fall out of the cabinet or could cause
damage to the tracks.
Figure 7.2 Location of switch and power supply in rack
RMBs
Power supply
Switch