Manualshelf

User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsFixed Non-Line of Site Wireless Data Link
81828384858687888990
6-63
2
Slip a small flat washer and small lock washer on the end of each bolt, then loosely re-
install the bolts into the 4 corners of the base station.
Note: Do NOT tighten the bolts into the base station fully. You will tighten the bolts in step
4, after you have hung the bolts, and therefore the attached base station, in the slots of the
top mounting clamp.
3 Install the top mounting clamps (brackets) around the pole
a Insert the threaded rods through the MP2 clamp.
Figure 6.14 Pole mounting clamps MP2 and MP 1
MP2 clamp (front clamp,
close to base station)
MP1 clamp (back clamp)