User's Manual

6-62 Configuring, Installing, and Using Carrier Infrastructure
Attaching mounting clamps to base station and around
pole
The pole mounting kit (part number 123-0350-1010) contains the hardware needed to mount
the base station to a pole.
• 2 front clamps (MP2)
• 2 back clamps (MP1)
• 4 threaded rods
• 4 large flat washers
• 4 small flat washers
• 4 large lock washers
• 4 small lock washers
•4 nuts
In addition to this hardware, you also use the 4 bolts that are pre-installed in the base station’s
4 legs (2 at top corners, 2 at bottom corners).
To install the pole mounting brackets to the base station and pole:
1 Remove the 4 bolts that are pre-installed on the base station.
Figure 6.13 Location of bolts on the back of the base station
Remove pre-installed bolts
from 4 corners of BTS