User's Manual

6-60 Configuring, Installing, and Using Carrier Infrastructure
c Make sure the area above and below the location where you want to install the base
station has a good distance for clearance. This clearance allows for proper air circulation
and heat flow from the heat sink fins on the back of the base station. The clearance also
allows for the coaxial cable and the other cable connections.
2 Drill mounting holes into the surface, according to the dimensions shown in Figure 6.11.
3 To attach the base station to a wall, use the mounting brackets. Install them on the base
station first, then attach the brackets to the wall. To attach the brackets to the base station,
use 5/16 inch x 18 inch UNC thread bolts and a lock washer which are supplied in the
installation kit. Use the optional bolts to then attach the bracket to the surface.
Mounting the base station to a pole or tower
Use the pole mounting kit (part number 123-0350-1010) to mount the BTS to a pole. Once
the BTS is installed on a pole, you can attach the pole to a tower, if desired.
Figure 6.11 Base station mounting template
10.375”
13.00"