User's Manual

6-59
5
Attach the antenna brackets to the bottom left and right sides of the base station.
If you want to tilt the antenna upward, use the middle or lower holes on the bracket.
• The second set of holes tilts the antenna 2 degrees upward.
• The third set of hole provides an additional 2 degrees of uptilt.
6 Tighten all hardware.
Mounting the base station
You can mount the base station to a wall, a pole or a rack.
Mounting the base station to a wall
To mount the base station to a wall:
1 Find a surface suited to base station installation.
a Use installation kit 123-0100-0130 to install the base station to a wall or back board. The
kit supplies a bracket and hardware that are necessary to mount the base station.
b Plan to install the base station vertically, so the antenna connector is at the top (facing
skyward), and the other circular connectors are at the bottom (facing the ground).
Figure 6.10 Antenna brackets on bottom left and right sides of base station
Top hole set
Middle holes
Bottom holes
2 additional degrees uptilt
2 degrees
uptilt
No tilt
Downtilt or
Top single hole for no tilt or downtilt