User's Manual

5-34 Configuring, Installing, and Using Carrier Infrastructure
set snmp state enabled
2 To specify the IP address of the remote computer or computers allowed to access the
SNMP server on the base station, specify a mask appropriate to your network. Type the
following command:
set snmp remote {IPaddress | IPaddress mask}
where:
IPaddress is the address of the remote machine that is allowed to access the SNMP server.
IPaddress mask is a mask for a range of all IP addresses that are allowed to access the base
station’s SNMP server.
3 If you want to use SNMP traps:
set snmp traps enabled
4 To specify the IP address of the SNMP trap server on the network management
workstation:
set snmp trap server {IPaddress}
where {IPaddress} is the IP address of the machine to receive SNMP traps.
5 Specify the trap level for the functions whose traps can be reported. To specify the level of
the SNMP trap messages that are sent to the trap server:
set snmp {function} traplevel {variable}
where:
{function} is the feature whose trap level you want to set. Functions you can specify include
airlink , config , nnmgr , reg mgr , relay , and stack .
{variable} is the trap level, with a value of
0 , 3 , 4 , 5 , or 7 .
For more information, refer to the guide “Using the NextNet Operating System
(NNOS).”