User's Manual

3-19
2
From the Configure page, click the Base Station Configuration link.
3 In the Enter new zones below, comma separated field, type the names of base station
zones. Use commas to separate names.
4 For load balancing purposes, you can enter limits on the amount of traffic that a base
station can handle on both the uplink and downlink. If a CPE tries to register with a base
station when either of the limits are met, the CPE will receive a notice that it should try to
register with another, less busy base station. If no such base station is available, the CPE
registers with the first base station.
• To specify the limit of uplink traffic that a base station can handle before the base
stations indicates to registering CPEs to look for another base station, type the limit in
the Uplink Base Threshold field.
• To specify the limit of downlink traffic, type the limit in the Downlink Base
Threshold field.
5 To specify the maximum number of VoIP calls that a base station can handle, type the
limit in the Max VoIP calls per Base field.
6 Click Save Zone Changes. The new zone names appear in the Zone column.
Registering with the AP server after Zones defined
After you define zones, the base stations must re-register with the AP server so that the AP
server recognizes the base station as having a correct zone.
To re-register the base station with the AP server:
1 Establish a terminal session with the base station.
Figure 3.6 Base Station Attributes page
CityCentral
CityNorth
CitySouth
CityEast
CityWest
4.3.8
MK