User's Manual

Index-106 Configuring, Installing, and Using Carrier Infrastructure
F
fuses
replacing, 7-89
RMB, 7-88
G
GPS
components of, 6-74
connecting to base station, 6-74
connector, 6-71
daisy-chained base stations, 6-75, 7-87
determining validity of output, A-97
exposure requirements, 6-74
interface cable, 6-72, 7-87
mounting pole and socket, 6-74
powering, 6-75
status codes, A-97
TDD impact, 1-8
time pulse generated, 6-74
used to generate time signal, 5-44
GPS inter-base station cable, 6-72, 7-87
grounding
RMB, 7-85
H
Hyperterminal
using to configure base station, 5-32
I
indoor/outdoor base station
overview, 1-2
inter-base station cable, 6-72, 7-87
ISPs
defining names, 3-20
L
lightning protection, 1-8, 6-74
antenna, 6-73
supplied through TVS module, 6-70
links
selecting, 2-12
local authority
setting up, 5-43
LOS requirement elimination, 1-1
M
MMDS frequency range
channels, B-99
mounting
brackets, 6-59
template, 6-60
N
network access
setting up for CPEs, 5-42
NNOS web interface
setting base station configuration
parameters, 5-35
P
power supply
for RMB, 7-83
provisioning server
user interface
New User page, 3-18
R
rack
attaching switch and power supply, 7-80
remote authority
setting up, 5-42
RMB
cell wiring diagram, 7-82
diagnostic cable, 7-88
Ethernet cable connection, 7-88
fuses, 7-88
grounding, 7-85
installation overview, 1-5
installing in cabinet, 7-80
LED locations and meaning, 7-86
overview, 1-2
power cable connectors, 7-87
power connectors, 7-84
power supply requirements, 7-83
wiring to cell, 7-81
RS-232 cable, 5-32
S
serial interface
cable, 6-73
connector, 6-72
set airlink channel, 5-36
set airlink downlink power, 5-36
set airlink state, 5-39
set downlink bias, 5-37
SNMP server equipment, 1-8
SNMP session
setting base station configuration
parameters, 5-35
subscribers
typical of the Expedience system, 1-1
Syslog
setting up options, 5-41
T
TDD, 5-44
technical support, preface-xvi
telnet access to base station, 5-32
telnet session