User's Manual

7-89
Figure 7.9 illustrates the Ethernet cable and fuses that correspond to each RMB.
Checking and replacing fuses
The system uses a standard fuse, AG3, 5 amps, 250 volts.
To remove a fuse from the cabinet:
1 Insert a flat head screw driver into the slot on the front of the gray fuse case.
2 Press in and turn the screw driver counter-clockwise about 1/8th of a turn, until the fuse
case pops out of the slot.
3 The fuse slides out of the back of the case.
Figure 7.9 Fuses and Ethernet cable connections on cabinet
1......................8 1..............8
Figure 7.10 Removing fuse from cabinet