User Manual

5-43
Setting legacy and management VLAN IDs
When the base station is shipped from the factory, the identification numbers for the legacy
VLAN and for the management VLAN are both set to 1.
If you or your ISPs use only CPEs that run Version 2.x software code or later, you do not
need to change the default id for either VLAN.
However, if you have some CPEs running version 1.x code, you need to set up a legacy
VLAN with an identification number different from the management VLAN ID. The legacy
VLAN then services all CPEs that run version 1.x software code.
set vlan legacy id
This command specifies the identification number for all legacy CPEs—CPEs that run
version 1.x software code. Make sure the legacy VLAN configuration setting is identical on all
base stations in the network.
Example: set vlan legacy id 4
set vlan mgmt id
This command specifies the identification of the management VLAN. The management
VLAN is used for network management. It also handles authorization protocol messages. All
base stations attach to the management VLAN. A network access provider must have one
management VLAN. The VLAN identification number must be the same number on all base
stations in the network.
Example: set vlan mgmt id 1
Setting up Syslog
This section describes how to set up Syslog options. Syslog is a tool that records operational
data, unusual system occurrences, system commands, and messages. To set up your system’s
Syslog options:
1 To enable Syslog, use a command line interface run over the network (such as telnet) or
use a serial line connection to the base station.
2 If you have not already done so, log on to NNOS. At the NNOS command prompt, issue
the following command to enable Syslog:
set syslog state enabled
3 Specify the level for the functions whose syslog events can be reported. To specify the
level of the messages:
set syslog {function} level {variable}
where:
{function} is the feature whose level you want to set. Functions you can specify include
airlink , config , nnmgr , reg mgr , and relay .
{variable} is the level, with a value of
0 , 3 , 4 , 5 , or 7 .
For further information about the functions and Syslog levels, refer to the guide “Using
the NextNet Operating System (NNOS).”
4 To set the Syslog port number:
set syslog port 514