User's Manual

10 Installing the low power base station
Powering the LPB
After you have run the cable from the LPB into the appropriate building, provide power to
the LPB.
To provide power to the LPB:
1 Plug the LPB communication cable running from the LPB into the end of the data line
protector which is labelled as unprotected. Figure 6 illustrates the data line protector.
Note: One side of the data line protector is marked “protected side” and the other side is
marked “unprotected side”. The protected side plugs to the direction of the power supply.
The unprotected side plugs to the direction of the LPB.
2 Use the ground cable provided with the data line protector to properly ground it. You can
use either ground terminal on the data line protector.
3 Plug a jumper cable into the end of the data line protector that is labelled as protected.
Insert the other end of the jumper cable into the power supply, in the jack labelled “OSU/
Power.”
4 Plug the power supply cord into a power source. The LPB uses standard AC power.
Figure 6 Data line protector
Grounding terminals