User's Manual

6 Installing the low power base station
4 Two sets of screw assemblies attach the bottom of the LPB to the mounting bracket. For
the bottom of the mounting bracket, assemble the screw (coated with anti-seize
compound), split lock washer, flat washer, ground wire, and double-tab washer, as shown
in Figure 3.
Let the ground wire dangle to the ground.
5 Tighten the screw inserted through the upper bracket and into the LPB in order to hold
the LPB in place.
6 On the bottom arm of the mounting bracket, tighten the bolt on the bottom of the LPB.
7 If you need to tilt the LPB’s internal antenna, loosen the screws in the adjustment arch,
then realign the screws with the degree of tilt you desire. The degrees (0 through 7) are
marked on the mounting bracket.
8 Plug in the circular end of the LPB communication cable in the bottom of the LPB.