User's Manual

5
Installing the LPB inside the mounting bracket
The LPB must be installed vertically. The LPB has a peg on the top, and a peg on the bottom.
The upper and lower pegs snap into the mounting bracket’s peg holes.
In addition to the pegs on the LPB, screws hold the LPB securely inside the mounting
bracket.
Slots in the mounting bracket allow you to tilt the LPB’s internal antenna from 0 to 7 degrees.
Setting the LPB inside the mounting bracket
You must install the LPB vertically. To install the LPB in the mounting bracket:
1 On the bottom arm of the mounting bracket, snap the LPB’s peg into the peg hole.
2 On the top arm of the mounting bracket, snap the LPB’s upper peg into the adjustment
arch.
To accommodate the height of the peg, you may need to lift the mounting bracket’s edge
up slightly.
3 Two sets of screw assemblies attach the top of the LPB to the mounting bracket. For the
top of the mounting bracket, assemble the screw (coated with anti-seize compound), split
lock washer and flat washer as shown in Figure 3.
Figure 3 Mounting bracket screw assembly