Installation Instructions

Nokia RoofTop™ Wireless Router Installation Guide 36
Connecting the multiwire cable
6.2 Connecting the multiwire cable
To enable the NPU’s operation you must connect the multiwire cable
wires to pin connections inside the NPU.
To prepare the NPU:
1.
Remove the Network/Power Unit from its packaging.
Inside view of the NPU
2.
Holding the multiwire cable, trim back the insulation about 2.5
inches. Make sure not to cut the metal braid and the foil. Slide the
insulation off (see picture below).
3.
Cut the metal braid, foil and plastic coating about half an inch above
the insulation and carefully peel it off (see picture below).