User Manual
Updating Firmware
Imitor Versio’s rmware can be updated by the user via our rmware webapp. In the
unlikely event that the need arises, rmware patches will be available on that site.
Alternate rmwares are also available on the webapp to transform your IV into a
completely dierent module.
Webapp link: https://portal.noiseengineering.us/
To update the rmware on your Imitor Versio:
1. Turn o the power to your case and unscrew IV.
2. Remove the power connector on the back of IV.
3. Plug a micro USB connector into the port on the pack of the module, and the other
end into your computer.
4. Follow the instructions in the webapp.
Design Notes
The main design goal of Imitor was to push the limits of what a multitap delay could do
on our new audio platform. The nal architecture was stereo 12 tap delay. The taps are
a stereo pair that simulates interaural time dierence for a rst-order binaural eect.
Most of the focus of Imitor is on the spacing and timing of the taps.
Take care when you’re using IV: we’re pretty sure it’s cursed. While testing it, we ran
into problem after problem after problem. Then, when we nally moved to bring IV into
production, the panels that were made had unexplainable mistakes on them and had to
be reprinted at the last minute. When we nally had a correct version of the module in
hand, we sent a pre-production unit to Patrick O’Brien to record a demo... But its audio
outputs were defective. On the way to drop a replacement on POB’s doorstep,
Stephen’s car blew a tire.
Maybe it’s got something to do with that pyramid on the panel?
Special Thanks
René Boscio
Erwin Coumans
Rob Vonderheide
5