User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濌濇澳
澳
4.3.2.2 Configure WLAN 15 General Setting (Station / CPE)
1. Go to Configuration > Wireless > Radio1 (5G) > WLAN 15 >
More…
2. Select Lock AP Mac checkbox to force station that associate the
AP with MAC address in Remote AP MAC only. This entry is optional.
3. Enter the desired SSID on Remote SSID that station is going to
associate or click
[Scan] to look for the surrounding SSID.
Figure 84 – 5G AP scan result
4. Select any one SSID checkbox shown on AP Scan Result, and then
click Select.
5. Enter up to three preferred AP MAC addresses on Preferred AP0 /
AP1 / AP2 Mac that station associates them preferentially. Preferred AP0
is the highest priority. These entries are optional.
6. Select Enable Roaming checkbox to enable roaming on station.
This entry is optional.
7. Enter SNR value from 0dB to 100dB on Scan SNR Threshold that
station performs channel scanning if the SNR of received signal from
serving AP is less than (<) this threshold; 35 is default setting.
8. Enter SNR value from 0dB to 100dB on Roaming SNR Threshold
that station triggers roaming from the serving AP to other AP if the SNR of
received signal from serving AP is less than (<) this threshold; 30 is default
setting.
Note:
- Scan SNR Threshold MUST be higher than (>)
Roaming
SNR Threshold