User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濆濇澳
澳
5G 600Mbps (802.11 ac HT40+)
5G 600Mbps (802.11 ac HT40-)
5G 1.3Gbps (802.11 ac HT80); Default Setting
6. Select Dynamic Radio Frequency Selection (DFS) checkbox to
enable automatic channel selection that selects the least congested channel
where radar is not detected during booting up.
Note:
- Radio Frequency is set as auto
automatically if DFS is
enabled
7. Select suitable operating channel on Radio Frequency;
Note:
-
You should select the suitable operating channel based
on the on-site channel scan result.
8. Select suitable transmission power on Transmission Power;
Note:
- You should follow the regulation from local
Communications Authority
9. Enter the maximum associated client between 1 and 256 on
Maximum Client that the radio interface serves. 256 is the default setting.
This entry is optional.
10. Select Disable HT20/HT40 Auto Switch checkbox that CPE
device will NOT switch the channel width between 20 MHz and 40 MHz
automatically. This entry is optional and only available for the following
wireless modes:
5G 450Mbps (802.11 n-only HT40+)
5G 450Mbps (802.11 na HT40+)
5G 450Mbps (802.11 na HT40-)
5G 450Mbps (802.11 n-only HT40-)