User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濅濃澳
澳
1. Go to Configuration > Wireless > Radio0 (2.4G) > WLAN # > More…
2. Select Enable WLAN checkbox to enable WLAN
3. Select Hide SSID checkbox to hide SSID name from its beacon frame.
This entry is optional.
4. Enter a unique name for the particular WLAN on SSID.
Note:
-
If you want to configure the same SSID on two different
WLANs; their security setting MUST be different from each other.
5. Select User Isolation checkbox to block user communication within the
same SSID in the AP directly. This entry is optional.
6. Deselect the DHCP Trust Port checkbox to prevent illegal DHCP
servers offering IP address to DHCP clients via this WLAN. This entry is
optional.
7. Specify the suitable privilege of associated clients on Access Traffic
Right; the options include
Full Access
Associated client can access Internet and
manage AP
AP Management Only
Associated client can manage AP only, but not
able to access the Internet
AP Management Disable
Associated client can access the Internet, but
not able to manage AP
8. Enter the maximum associated clients between 1 and 256 on Max
Clients for this WLAN. 256 is the default setting.
Note:
- Max Clients in WLAN 0 – 15 MUST be smaller
than or
equal to (൒) the Max Clients setting on Radio General Setting
9. Enter an additional requirement on Signal Strength to Noise Ratio
(SNR) for associated clients under Station Association Requirement.
These entries are optional. Network ad may fill up the following fields:
Reject Station
Association if SNR less
than
X dB
X denote the minimum SNR level which
allow clients to associate; You can select any
integer between
0dB and 100dB; 0
denotes as
disable; 0 is default setting