User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濌澳
澳
9. Enter the maximum associated client between 1 and 256 on
Maximum Client that the radio interface serves. 256 is the default setting.
This entry is optional.
10. Select Disable HT20/HT40 Auto Switch checkbox that CPE
device will NOT switch the channel width between 20 MHz and 40 MHz
automatically. This entry is optional and only available for the following
wireless modes:
2.4G 450Mbps (802.11 ng HT40+)
2.4G 450Mbps (802.11 n-only HT40+)
2.4G 450Mbps (802.11 ng HT40-)
2.4G 450Mbps (802.11 n-only HT40-)
11. Select Enable Inter-WLAN User Isolation checkbox that CPE
device block the users’ communication across different SSID on the same
AP directly. This entry is optional.
12. Select Periodic Auto Channel Section checkbox to enable
scheduled channel selection task on the radio interface. This entry is
optional and only available if auto is selected on Radio Frequency. The
available schedule modes are:
Schedule Mode
Select exact time and day(s) for selecting radio frequency
for the interface
Periodic Mode
Select a countdown timer (minute) for selecting radio
frequency for the interface; 0 denotes disable.
13. Click Submit
4.1.1.2 Configure WLAN # General Setting
Figure 16 – 2.4G WLAN # General Setting