User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濅濌澳
澳
- If providing NTP server’s domain name in NTP Server IP,
you must provide valid DNS server information (Refer to
Assign an
IP Address to CPE Device on page 14 for more detail)
8. STP
Spanning Tree Protocol (STP) is a network protocol that ensures a loop-free topology
for any bridged Ethernet local area network.
Figure 119 – STP Setting
1. Go to Configuration > Network > General > STP Setting
2. Select Enable STP Mode checkbox to enable spanning tree
protocol on CPE device
3. Click Submit
4. Click
Save & Apply from the top on the right.