User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濅濋澳
澳
7. Network Time Protocol (NTP) Settings
For successful and proper communication between various elements in a network,
time synchronization between the elements and across the network is critical. Network
Time Protocol (NTP), a networking protocol for clock synchronization, is required to obtain
the precise time from a server and to regulate the local time in each network element. The
NTP server on CPE devices is set to 0.pool.ntp.org by default.
Figure 118 – NTP Setting
1. Go to Configuration > System > NTP Setting
2. Enter either the domain name / IP address of NTP server which you
want to synchronize with on NTP Server IP.
Note:
- Click for adding more NTP Server entry;
- Click to remove existing NTP server entry
3. Enter suitable polling interval between 15s and 86400s on NTP
Polling Interval that specifies the interval between each synchronization
request from the CPE device to NTP server(s). 600s is default setting.
4. Select appropriate time zone on NTP Time Zone; Asia/Hong Kong
is default setting
5. Click Daylight Saving Time checkbox if your place has daylight
saving time
6. Click Submit
7. Click
Save & Apply from the top on the right.
Note:
- IP Address Type
is changed by AP automatically based
on whether IPv6 is enabled or not