User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濅濈澳
澳
6.3 Create VLAN Profile
Figure 115 – VLAN Profile Setting
1. Go to Configuration > Network > VLAN > VLAN Profile
2. Click Add VLAN
3. Enter an identification number between 1 and 4094 on VLAN ID
that is an unique identification representing a VLAN
4. Enter valid IP Address on IPv4 Address of CPE device in the VLAN
5. Enter valid IP subnet mask on IPv4 Subnet Mask of the VLAN
6. Click Enable STP Mode checkbox to enable Spanning Tree
Protocol (STP) on this VLAN profile
7. Click Submit
Note:
- Click to remove the existing VLAN profile
6.4 Specify Management VLAN Profile
Management VLAN stands for an IP network that can provide remote administration.
Network administrator can access the Web UI via the management VLAN only if VLAN is
enabled on CPE device.