User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濅濅澳
澳
5G Interface: Go to Configuration > Wireless > Radio1(5G) >
Advanced > Advanced Settings
2. Select Nearby AP List checkbox to enable that CPE sniffs the
surrounding AP periodically; The result list is shown on the corresponding
radios’ status information
3. Click Submit
4. Click
Save & Apply from the top on the right.
5.9. IGMP Snooping
CPE acts as a Layer 2 device when it is configured as Switch mode. However, IGMP
Snooping implementation on CPE is a little bit different than that of standard Layer 2 Switch.
Typically, IGMP Snooping allows a switch to only forward multicast traffic to the links
that have at least one client joined the multicast group. Unlike ordinary IGMP Snooping
implementation, CPE converts multicast to unicast and delivers them to devices registered
with the multicast group.
When IGMP Snooping is turned on, multicast packets should be dropped at the WLAN
exit if there is no client from the WLAN who has joined the corresponding multicast group.
Figure 112 – IGMP Snooping Setting
1. 2.4G Interface: Go to Configuration > Wireless > Radio0(2.4G) >
Advanced > Advanced Settings
5G Interface: Go to Configuration > Wireless > Radio1(5G) >
Advanced > Advanced Settings
2. Select IGMP Snooping checkbox to enable IGMP Snooping
3. Click Submit
4. Click
Save & Apply from the top on the right.
5.10. Multicast Traffic
Network administrator allows CPE to process or discard the multicast traffic by
configuring the multicast traffic option on Web UI.