User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濄澳
澳
> Network and Sharing Center > Change adapter settings.
2. Right-click the icon for Local Area Connection, and then click
Properties.
3. When the Local Area Connection Properties dialog box appears,
select Internet Protocol (TCP/IP) (or Internet Protocol Version 4
(TCP/IPv4)) from the scrolling list, and then click Properties. The Internet
Protocol (TCP/IP) Properties dialog box appears.
4. Write down all of the currently active network settings. You will need
this information later when you restore your computer to its current network
configuration.
5. Configure the IP address settings with the values listed in
6. Table 2.
Table 2 - Configure administrative computer’s IP address settings
IP Address
Any address
in the 192.168.1.x, except 192.168.1.222
and 192.168.1.255
Example: 192.168.1.2
Subnet Mask
255.255.255.0
Default Gateway
Blank
DNS
Blank
7. Click OK to save the changes and close the TCP/IP Properties
dialog box.
8. Click OK again to close the Local Area Connection Properties
dialog box.
3.2. Connecting Access Point
1. Provide 12-48v dc power supply for CPE .
2. Connect your laptop to Ethernet port of the CPE using Ethernet
cable.