User Manual

濖濣濘激濅濇濈濋激濔濖激濦激濜澳濖瀂瀁濹濼濺瀈瀅濴瀇濼瀂瀁澳濠濴瀁瀈濴濿澳
濄濃濊澳
澳
the only encryption algorithm supported by the 802.11i standard.
If Authentication Mode is WPA2:
AES
This algorithm provides enhanced security over TKIP, and is
the only encryption algorithm supported by the 802.11i standard.
If Authentication Mode is WPA-auto:
TKIP
+ AES
This algorithm automatically selects TKIP or AES based on
the client’s capabilities
Note:
-
TKIP is not supported by 802.11n standard. If selected
TKIP, the 802.11n’s devices will be limited to 802.11g transfer rate,
i.e. up to 54 Mbps
4. Enter suitable identification on NAS identifier. Remote RADIUS
server uses this ID to identify its clients. This entry is available for WPA and
WPA2 only.
5. Enter transmission timeout interval between 0 and 86400s on
RADIUS Retry Timeout. 300 is default setting. This entry is optional.
6.
Enter IP address of remote RADIUS server for authentication in IP
Address of RADIUS Server
7. Enter service port of remote RADIUS server in Port of RADIUS
Server. 1812 is default setting.
8.
Enter suitable secrets in Secret of RADIUS Server. It is used along
with the MD5 hashing algorithm to obfuscate passwords. This secret MUST
be as the same as that in RADIUS server.
9. Repeat step 6-8 if the backup RADIUS server is available. It is
optional.
10. Enter interval between each interim update in seconds on
Accounting interim Interval. 300 is default setting. This entry is optional.
11.
Enter IP address of remote RADIUS Accounting Server on IP Address
of RADIUS Accounting Server. This entry is optional.
12. Enter service port of remote RADIUS server in Port of RADIUS
Accounting Server. 1813 is default setting. This entry is optional.
13. Enter suitable secrets in Secret of RADIUS Accounting Server. It
is used along with the MD5 hashing algorithm to obfuscate passwords. This
secret MUST be as the same as that in RADIUS server. This entry is optional.