Configuration Manual

Dual-band 3x3 802.11 ac WiFi Access Point

7. Specify the suitable privilege of associated clients on Access Traffic

Right; the options include

Full Access - Associated client can access Internet and manage AP

AP Management Only - Associated client can manage AP only, but not

able to access the Internet

AP Management Disable - Associated client can access the Internet, but

not able to manage AP

8. Specify the maximum associated clients between 1 and 256 on Max

Clients for this WLAN. 256 is the default setting.

Note:

- Max Clients in WLAN 0 – 15 MUST be smaller than or equal to

( ) the Max Clients setting on Radio General Setting

9. Specify an additional requirement on Signal Strength to Noise Ratio

(SNR) for associated clients under Station Association Requirement.

This requirement is optional. You may fill up the following fields:

Reject Station Association if

SNR less than X dB

X denote the minimum SNR level which allow

clients to associate; You can select any

integer between 0dB and 100dB; 0 denotes

as disable; 0 is default setting

Disassociate Station if SNR

drops more than Y dB for

consecutive Z packets

Y denotes the SNR tolerance; Z denotes the

number of consecutive packets their SNR

are below the difference of X - Y.

Notes:

- Example for Station Association Requirement with the

following settings:

Reject Station Association if SNR less than 30 dB (X = 30);

Disassociate Station if SNR drops more than 20 dB for

consecutive 10 packets (Y = 20; Z = 10)

Consequence:

AP accepts the clients to associate if the SNR of packets from

the clients is high than (>) 30dB;

AP kicks out the associated client if the SNR of 10 consecutive

packets is below (<) 10 dB (30 dB – 20 dB)

10. Click Submit