Configuration Manual

84
Dual-band 3x3 802.11 ac WiFi Access Point
Configuration Manual
3. Enter the desired SSID on Remote SSID that station is going to
associate or click [Scan] to look for the surrounding SSID.
Figure 85 – 5G AP scan result
4. Select any one SSID checkbox shown on AP Scan Result, and then
click Select.
5. Enter up to three preferred AP MAC addresses on Preferred AP0 /
AP1 / AP2 Mac that station associates them preferentially. Preferred
AP0 is the highest priority. These entries are optional.
6. Select Enable Roaming checkbox to enable roaming on station. This
entry is optional.
7. Enter SNR value from 0dB to 100dB on Scan SNR Threshold that
station performs channel scanning if the SNR of received signal from
serving AP is less than (<) this threshold; 35 is default setting.
8. Enter SNR value from 0dB to 100dB on Roaming SNR Threshold that
station triggers roaming from the serving AP to other AP if the SNR of
received signal from serving AP is less than (<) this threshold; 30 is
default setting.
Note:
- Scan SNR Threshold MUST be higher than (>) Roaming SNR
Threshold
9. Specify the duration from 1s to 3600s on Max Scan Interval for
channel scanning; 60s is default setting. AP device conducts at least
one scanning within this interval.
10. Specify the duration from 1s to 60s on Min Scan Interval for channel
scanning; 10s is default setting. No more than one scanning will be
conducted within this interval. This parameter is to prevent too often
channel scanning from affecting the data transmission.
Note:
- Max Scan Interval MUST be higher than (>)Min Scan Interval