Configuration Manual

Dual-band 3x3 802.11 ac WiFi Access Point

Configure to associate network with WPA-PSK / WPA2-PSK

authentication

Figure 70 – WLAN15 Security Setting – Associating WLAN with WPA-PSK / WPA2-PSK

authentication

1. Go to Configuration > Wireless > Radio0(2.4G) > Station

Configuration > WLAN15 > WLAN Security

2. Select WPA-PSK / WPA2-PSK in Authentication Mode

3. Select suitable encryption mode in Cipher Mode as the followings:

If Authentication Mode is WPA:

TKIP + AES

This algorithm automatically selects TKIP or AES based on the

client’s capabilities

TKIP

This algorithm provides greater compatibility with older client

devices, but is not supported by the 802.11n standard.

AES

This algorithm provides enhanced security over TKIP, and is the

only encryption algorithm supported by the 802.11i standard.

If Authentication Mode is WPA2:

AES

This algorithm provides enhanced security over TKIP, and is the

only encryption algorithm supported by the 802.11i standard.

If Authentication Mode is WPA-auto:

TKIP + AES

This algorithm automatically selects TKIP or AES based on the

client’s capabilities

4. Enter an ASCII string between 8 and 63 characters long or a HEX

string with 64 characters long on Pass Phrase that matches with

remote AP

5. Click Submit