Configuration Manual

ManualsBrandsNodes ManualsElectronicsWiFi AP/CPE

Dual-band 3x3 802.11 ac WiFi Access Point

Configure WLAN as Open network with Shared Key Authentication .................................................... 93

Configure WLAN with WPA / WPA2 / WPA-auto Authentication ......................................................... 94

Configure WLAN with WPA-PSK / WPA2-PSK / WPA-auto-PSK Authentication ................................... 96

Configure WLAN with WAPI Authentication .......................................................................................... 97

Configure WLAN with WAPI-PSK Authentication ................................................................................... 99

Step 7: Configure ACL Setting ..................................................................................................................... 100

Step 8: Configure WLAN # QoS ................................................................................................................... 100

Step 9: Configure WLAN # Bandwidth Control .......................................................................................... 101

Step 10: Apply Submitted Configurations on the AP Device ..................................................................... 101

4.4. BRIDGE MODE ................................................................................................................... 102

5. ADVANCED RADIO SETTINGS .................................................................................................. 103

5.1. DISTANCE SETTING .............................................................................................................. 103

5.2. SHORT GUARD INTERVAL ...................................................................................................... 104

5.3. AIRFI ............................................................................................................................... 105

5.4. DATA RATE SETTING ............................................................................................................ 105

Configure Data Rate ................................................................................................................ 106

Configure Multicast Rate ......................................................................................................... 106

5.5. FRAME AGGREGATION ......................................................................................................... 107

5.6. SPATIAL STREAMING ............................................................................................................ 107

5.7. DELIVERY TRAFFIC INDICATION MESSAGE (DTIM) TIME ............................................................... 108

5.8. WIFI PROTECT MECHANISM [HIDDEN NODE PROBLEM] ................................................................ 109

5.9. BEACON INTERVAL OF BSS .................................................................................................... 110

5.10. NEARBY AP LIST ................................................................................................................. 110

5.11. IGMP SNOOPING ............................................................................................................... 111

5.12. MULTICAST TRAFFIC ............................................................................................................ 111

6. VLAN CONFIGURATION ........................................................................................................... 112

STEP 1: CONFIGURE RADIO SETTINGS .................................................................................................... 112

STEP 2: ENABLE VLAN ...................................................................................................................... 112

STEP 3: CREATE VLAN PROFILE ........................................................................................................... 113

STEP 4: SPECIFY MANAGEMENT VLAN PROFILE ...................................................................................... 113

STEP 5: ASSIGN VLAN PROFILE ON INTERFACE AS ACCESS PORT .................................................................. 114

STEP 6: ASSIGN VLAN PROFILE ON INTERFACE AS TRUNK PORT .................................................................. 114

STEP 7: APPLY SUBMITTED VLAN CONFIGURATIONS ON THE AP DEVICE ....................................................... 115

7. NETWORK TIME PROTOCOL (NTP) SETTINGS .......................................................................... 116

8. STP .......................................................................................................................................... 117

9. SAFE MODE ............................................................................................................................. 118

10. QUALITY OF SERVICE (QOS) .................................................................................................... 119

11. IP GATEWAY ........................................................................................................................... 121

11.1. IP GATEWAY ...................................................................................................................... 121

Step 1: Configure WAN IP Setting ............................................................................................ 121

Step 2: Configure Radio Settings .............................................................................................. 121

Step 3: Enable Gateway Mode ................................................................................................. 121

Step 4: Configure LAN IP Setting .............................................................................................. 121

Step 5: Assign Interface(s) as WAN Interface ........................................................................... 122

Step 6: Assign Interface(s) as LAN Interface ............................................................................. 122

Step 7: NAT Setting .................................................................................................................. 122

Step 8: Apply Submitted Configurations on the AP Device ........................................................ 123

11.2. DHCP SERVER ................................................................................................................... 123

Step 1: Configure as Gateway Mode ........................................................................................ 123

Step 2: Enable DHCP Server ..................................................................................................... 123

Step 3: Assign IP Address Range for Leasing on DHCP Server ................................................... 124

Step 4: Apply Submitted Configurations on the AP Device ........................................................ 124