Configuration Manual

Dual-band 3x3 802.11 ac WiFi Access Point

1. Go to Configuration > Wireless > Radio1(5G) > WLAN > WLAN # >

WLAN Security

2. Select WAPI on Authentication Mode

3. Select SMS4 in Cipher Mode

4. Enter in an ASCII string between 8 and 63 characters or a HEX string

with 64 characters long in Pass Phrase that users will use to connect

to the wireless network.

5. Enter interval time between 60 and 2147483647s in Unicast Key

Update Interval; 86400 is default setting. This entry is optional.

6. Enter interval time between 60 and 2147483647s in Multicast Key

Update Interval; 86400 is default setting. This entry is optional.

7. Click Submit

Step 4: Configure ACL Setting

Figure 40 - 5G WLAN #ACL Setting

1. Go to Configuration > Wireless > Radio0(2.4G) > WLAN > WLAN # >

ACL Setting

2. Select appropriate option on Access Control List; options include

Disable

ACL is disabled

Enabled – Default Allow

ACL is enabled. The MAC addresses which

are specified in the ACL will consider as

Deny. Every wireless client can associate

to the AP unless its MAC address is on the

list

Enabled – Default Deny

ACL is enabled. The MAC addresses which

are specified in the ACL will consider as

Allow. Every wireless client CANNOT

associate to the AP unless its MAC address

is on the list

3. Select Manual Input on ACL Input Method if network administrator

prefers input the entry one by one manually

Or select File on ACL Input Method if network administrator prefers

upload a MAC address list (.txt file)

4. Enter MAC address entry one by one or upload the corresponding

file to AP; it is optional

5. Click Submit

Note:

- Network Administrator shall select Disable or Enabled –

Default Allow if no ACL entry will be input on AP