Configuration Manual

Dual-band 3x3 802.11 ac WiFi Access Point

6. Select Dynamic Radio Frequency Selection (DFS) checkbox to

enable automatic channel selection that selects the least

congested channel where radar is not detected during booting up.

Note:

- Radio Frequency is set as auto automatically if DFS is enabled

7. Select suitable operating channel on Radio Frequency;

Note:

- You should select the suitable operating channel based on

the on-site channel scan result.

8. Select suitable transmission power on Transmission Power;

Note:

- You should follow the regulation from local Communications

Authority

9. Enter the maximum associated client between 1 and 256 on

Maximum Client that the radio interface serves. 256 is the default

setting. This entry is optional.

10. Select Disable HT20/HT40 Auto Switch checkbox that AP device will

NOT switch the channel width between 20 MHz and 40 MHz

automatically. This entry is optional and only available for the

following wireless modes:

5G 450Mbps (802.11 n-only HT40+)

5G 450Mbps (802.11 na HT40+)

5G 450Mbps (802.11 na HT40-)

5G 450Mbps (802.11 n-only HT40-)

11. Select Enable Inter-WLAN User Isolation checkbox that AP device

block the users’ communication across different SSID in the AP

directly. This entry is optional.

12. Select Periodic Auto Channel Section checkbox to enable

scheduled channel selection task on the radio interface. This entry is

optional and only available if auto is selected on Radio Frequency.

The available schedule modes are:

Schedule Mode

Select exact time and day(s) for selecting radio

frequency for the interface

Periodic Mode

Select a countdown timer (minute) for selecting radio

frequency for the interface; 0 denotes disable.

13. Click Submit