Configuration Manual

Dual-band 3x3 802.11 ac WiFi Access Point

If Authentication Mode is WPA2:

AES

This algorithm provides enhanced security over TKIP, and is the

only encryption algorithm supported by the 802.11i standard.

If Authentication Mode is WPA-auto:

TKIP + AES

This algorithm automatically selects TKIP or AES based on the

client’s capabilities

Note:

- TKIP is not supported by 802.11n standard. If selected TKIP, the

802.11n’s devices will be limited to 802.11g transfer rate, i.e.

up to 54 Mbps

4. Enter suitable identification on NAS identifier. Remote RADIUS server

uses this ID to identify its clients. This entry is available for WPA and

WPA2 only.

5. Enter transmission timeout interval between 0 and 86400s on RADIUS

Retry Timeout. 300 is default setting. This entry is optional.

6. Enter IP address of remote RADIUS server for authentication in IP

Address of RADIUS Server

7. Enter service port of remote RADIUS server in Port of RADIUS Server.

1812 is default setting.

8. Enter suitable secrets in Secret of RADIUS Server. It is used along with

the MD5 hashing algorithm to obfuscate passwords. This secret MUST

be as the same as that in RADIUS server.

9. Repeat step 6-8 if the backup RADIUS server is available. It is

optional.

10. Enter interval between each interim update in seconds on

Accounting interim Interval. 300 is default setting. This entry is

optional.

11. Enter IP address of remote RADIUS Accounting Server on IP Address of

RADIUS Accounting Server. This entry is optional.

12. Enter service port of remote RADIUS server in Port of RADIUS

Accounting Server. 1813 is default setting. This entry is optional.

13. Enter suitable secrets in Secret of RADIUS Accounting Server. It is

used along with the MD5 hashing algorithm to obfuscate passwords.

This secret MUST be as the same as that in RADIUS server. This entry is

optional.

14. Repeat step 11-13 if the backup RADIUS Accounting server is

available. It is optional.

15. Click Submit