Configuration Manual

Dual-band 3x3 802.11 ac WiFi Access Point

10. Select Disable HT20/HT40 Auto Switch checkbox that AP device will

NOT switch the channel width between 20 MHz and 40 MHz

automatically. This entry is optional and only available for the

following wireless modes:

2.4G 450Mbps (802.11 ng HT40+)

2.4G 450Mbps (802.11 n-only HT40+)

2.4G 450Mbps (802.11 ng HT40-)

2.4G 450Mbps (802.11 n-only HT40-)

11. Select Enable Inter-WLAN User Isolation checkbox that AP device

block the users’ communication across different SSID on the same

AP directly. This entry is optional.

12. Select Periodic Auto Channel Section checkbox to enable

scheduled channel selection task on the radio interface. This entry is

optional and only available if auto is selected on Radio Frequency.

The available schedule modes are:

Schedule Mode

Select exact time and day(s) for selecting radio

frequency for the interface

Periodic Mode

Select a countdown timer (minute) for selecting radio

frequency for the interface; 0 denotes disable.

13. Click Submit

Step 2: Configure WLAN # General Setting

Figure 17 – 2.4G WLAN # General Setting

1. Go to Configuration > Wireless > Radio0 (2.4G) > WLAN # > More…

2. Select Enable WLAN checkbox to enable WLAN

3. Select Hide SSID checkbox to hide SSID name from its beacon frame.

This entry is optional.