Configuration Manual

10
Dual-band 3x3 802.11 ac WiFi Access Point
Configuration Manual
Step 4: System Info Setting
Figure 9 – System Info Setting
1. Click Configuration > System
2. Type in a string up to 255 characters in System Name; this entry is
optional
3. Type in a string up to 64 characters in System NE ID; this entry is
optional
4. Type in a string up to 255 characters in System Location; this entry is
optional
5. Select Power Save PoE checkbox if AP is powered by a PoE switch
that is compliant with 802.3af only.
6. Click Submit
Note:
- In 802.3af power safe mode, AP will operate in 2x3 MIMO with
maximum transmission power 24 dBm.
Step 5: Assign an IP Address to AP Device
Assign Static IPv4 IP Address
Figure 10 – IPv4 WAN Setting (Static IP Address)
1. Go to Configuration > Network > General > WAN Settings (IPv4)
2. Select Static on Internet Connection Type
3. Enter valid IP Address on IPv4 Address; 192.168.1.222 is the default
setting
4. Enter valid IP subnet mask on IPv4 Subnet Mask; 255.255.255.0 is
default setting