Configuration Manual

152

Dual-band 3x3 802.11 ac WiFi Access Point

1. Go to Tools > Diagnosis > traceroute

2. Type target IP address / host name in Destination IP Address/Host

Name

3. Click Enable Resolve IP addresses checkbox to enable IP address to

domain name translation; this entry is optional

4. Specify timeout interval between 1s and 100s in Timeout for

traceroute test; this entry is optional

5. Specify TTL value between 1 and 100 in Pings Per TTL; 3 is default

setting. This entry is optional

6. Specify TTL value between 1 and 100 in Maximum TTL; 30 is default

setting. This entry is optional

7. Click Start

8. Click Stop to terminate ping test if necessary

18.6. Tcpdump

AP provides a tool to capture packets that passing through a particular

interface. It helps network administrator for troubleshooting.

Figure 163 – Tcpdump Tool

1. Go to Tools > Diagnosis > Tcpdump

2. Select suitable interface in Interface

3. Specify maximum number of packet in Packet Count; this entry is

optional

4. Specify maximum file size in Capture File Size; this entry is optional

5. Click Start

6. Click Stop to terminate ping test if necessary

7. Download capture file after finished.