Configuration Manual

151

Dual-band 3x3 802.11 ac WiFi Access Point

18.4. Ping Test

Network administrator and engineer test the reachability of a host and

measures the round-trip time between AP and the host over an Internet

Protocol (IP) network by using ping tool.

Figure 161 – Ping Test

1. Go to Tools > Diagnosis > Ping

2. Type target IP address / host name in Ping IP Address/Host Name

3. Specify how many ICMP (ping) packet that AP sends to the target

host in Packet Count; 4 is default setting. This entry is optional.

4. Specify the packet size of ICMP packet in Packet Size; 56 is default

setting. This entry is optional.

5. Click Start

6. Click Stop to terminate ping test if necessary

18.5. Traceroute Test

Network administrator tests the route (path) and measuring transit

delays of packets across an Internet Protocol (IP) network by using

traceroute test.

Figure 162 – Tracerout Test