Configuration Manual

137

Dual-band 3x3 802.11 ac WiFi Access Point

15. SNMP

Simple Network Management Protocol (SNMP) is a Network

management protocol used almost exclusively in TCP/IP networks.

SNMP provides a means to monitor and control network devices, and

to manage configurations, statistics collection, performance, and

security.

Figure 145 – SNMP Setting

1. Go to Administration > User Admin > SNMP

2. Select Enable SNMP checkbox to enable SNMP function

3. Type in suitable string in Read Community; the string of Read

Community between Network Manage System (NMS) and AP must

be identical, otherwise, NMS cannot get information from AP. public

is default setting.

4. Type in suitable string in Write Community; the string of Write

Community between Network Manage System (NMS) and AP must

be identical, otherwise, NMS cannot modify AP’s setting. netman is

default setting.

5. Click Submit

6. Click Save & Apply

Note:

- AP support up to four trap host at the same time. The

information about trap hosts will be listed in the trap host table