Configuration Manual

124

Dual-band 3x3 802.11 ac WiFi Access Point

Step 3: Assign IP Address Range for Leasing on DHCP

Server

Figure 132 – Address Pool Setting

1. Go to Configuration > Network > DHCP

2. Click on any Pool ID

3. Click Enable Pool checkbox

4. Enter the first valid IP address on Start IP Address

5. Enter the last valid IP address on End IP Address

6. Enter lease time between 60s and 604800s on Default Lease Time;

86400s is default setting.

7. Click Submit

Note:

- All IP address for leasing MUST be within the LAN IP subnet

(Refer to Step 4: Configure LAN IP Setting on page 121 for

more detail)

Step 4: Apply Submitted Configurations on the AP

Device

1. Click Save & Apply from the top on the right.

11.3. Port Forward

Port forward is an application of Network Address Translation (NAT) that

redirects a communication request between WAN interface(s) and

LAN interface(s) while the packets are traversing AP device in gateway

mode. This technique is most commonly used to make services on a

host residing on LAN interface(s) available to hosts on WAN interface(s),

by remapping the destination IP address and port number of the

communication to a host on LAN side.