Configuration Manual

113

Dual-band 3x3 802.11 ac WiFi Access Point

Step 3: Create VLAN Profile

Figure 119 – VLAN Profile Setting

1. Go to Configuration > Network > VLAN > VLAN Profile

2. Click Add VLAN

3. Enter an identification number between 1 and 4094 on VLAN ID that

is an unique identification representing a VLAN

4. Enter valid IP Address on IPv4 Address of AP device in the VLAN

5. Enter valid IP subnet mask on IPv4 Subnet Mask of the VLAN

6. Click Enable STP Mode checkbox to enable Spanning Tree Protocol

(STP) on this VLAN profile

7. Click Submit

Note:

- Click to remove the existing VLAN profile

Step 4: Specify Management VLAN Profile

Management VLAN stands for an IP network that can provide remote

administration. Network administrator can access the Web UI via the

management VLAN only if VLAN is enabled on AP device.

Figure 120 – Management VLAN Setting